SRAM RockShox Super Deluxe Coil Service Manual page 41

4 Clamp the catcher in a vise or hold it secure with a 13 mm wrench.
Use a second 13 mm wrench to thread the push pin along the rod until
it pushes the bushing pin into the shock eyelet bushing.
Continue to thread the push pin until the bushing pin protrudes from
both sides of the eyelet an equal amount.
You may need to unthread the catcher slightly to check the bushing
pin spacing.
5 Press an end spacer, large diameter side first, onto each end of the
bushing pin.
6 Reinstall the shock to your bicycle frame according to the bicycle
manufacturer's instructions.
This concludes the service for the RockShox Super Deluxe Coil rear shock.
13 mm
Mounting Hardware Installation
41