Table of Contents
Advertisement
5
Place your thumb on the IFP to prevent it from moving, then slowly
install the shaft assembly into the damper body until the threads of the
sealhead contact the damper body.
Oil will overflow from the damper body. Place a shop towel below the
shock.
Pressure will continue to build against the IFP as the shaft assembly
is tightened. Keep your thumb on the IFP to ensure the best bleed.
Remove your thumb once the shaft assembly has been tightened.
⚠ CAUTI ON - EYE HAZARD
Oil can eject from the damper body. Wear safety glasses.
6
Continue to apply pressure to the IFP while threading the sealhead into
the damper body until resistance is felt.
Release pressure on the IFP.
7
Insert a new nylon compression ball into the bleed port.
Install the bleed screw into the bleed port and thread it in until you feel
it contact the nylon compression ball, then tighten the bleed screw an
additional ½ turn.
To ensure proper function, do not reuse the compression ball.
8
Tighten the sealhead to 34 N•m (300 in-lb).
NOTI CE
Counter Measure Wrench
Super Deluxe Coil Assembly and Bleed
T10
34 N•m (300 in-lb)
34
Advertisement
Table of Contents
