Table of Contents
Advertisement
Operating Instructions
44
How to Switch On the Laser
Note: If parameter "state" is grayed out and "SLock" or "SL" is shown in
the status line, refer to chapter "Soft Lock" on page 36.
• Move to parameter "state".
• Press [Enter], the Modify Knob, or the [Edit] soft key to start editing the
value.
• Use the Up or Down key or the Modify Knob to select the laser state.
• When finished press [Enter], the Modify Knob, or the [OK] soft key. You
can also cancel the operation using the [Cancel] soft key.
You can also use the module's front panel key to switch the laser state.
N O T E
The Graphical User Interface
Agilent 81950A Compact TLS module, First Edition
Advertisement
Table of Contents
