Changing The Savecard; Inserting / Changing The Power Supply Unit (Power Module) - Primedic DefiMonitor XD Series Operating Manual

5.2.2
5.3
21324 / 09.05 / 02 / GB
DefiMonitor XD
A file that is loaded automatically after switching on and / or after inserting the
power module is saved on the SaveCard. This file contains the four languages rele-
vant for your use. Then the DefiMonitor begins operation and runs the self-test. After
the file is loaded by DefiMonitor, SaveCard does not delete it. Create a backup of the
file afterwards. As the file uses about 4 MB of the storage space, we recommend that
you delete the file with the help of a PC to create more space on the SaveCard.
After each use, the data stored on the SaveCard should be archived on external me-
dia as soon as possible. No further data can be stored if there is no space left on the
SaveCard. PRIMEDIC™ DefiMonitor can be used even if there is no space to store
data and even without the SaveCard.

Changing The SaveCard

To be able to remove / change the SaveCard, the power module must be removed
first! Open the compartment by pushing the cover in the towards the power module
compartment. Afterwards, push in button (1) completely – thereby a part of the
SaveCard(2) is pushed out of the slot.
Remove the SaveCard from the device completely, transfer the data (if required) to a
PC and insert this card or a new one with the connector side into the device first.
Press in the card lightly until the button (1) juts out from the opening.
Then put the power module back into the device.

Inserting / Changing the Power Supply Unit (Power Module)

PRIMEDIC™ DefiMonitor can be operated on two different power modules.
- rechargeable AkuPak or
- via mains power supply.
If you operate the DefiMonitor exclusively via the internal power pack, you must en-
sure that the AkuPak energy module shaft is inserted. Without it, the DefiMonitor
cannot be operated.
Before using PRIMEDIC™ DefiMonitor for the first time, the power module must be
inserted in the compartment provided for it.
Check the power supply after every use. Check whether the AkuPak should be
charged. If this is not possible, another charged AkuPak should be available to en-
sure ready usability!
Operating Manual
25