Ceiling Hardware; Adaptor Plate Installation - Casablanca 19th Century Owner's Manual

CROSSBAR
MOUNTING
BRACKET
Note: After removing the old fixture, check the outlet box
to insure that it is supported by a joist or beam across its
upper surface. If not, a 2" x 4" stud must be installed.
Step 1. Remove the knockout plug in the center of the outlet
1
box or drill a " hole for the lag screw to pass through. Then
/
2
drill a 1 " guide hole into the joist or beam to a depth of 3".
/
4
CAUTION: To reduce the risk of personal injury,
use only the mounting hardware provided with
the approved outlet box to install the crossbar
mounting bracket.
WARNING!
SUPPORT DIRECTLY TO
BUILDING STRUCTURE ONLY.
19

CEILING HARDWARE

WIRE NUT (4)
SUPPORT INSTALLATION PARTS
CANOPY
ADAPTOR
PLATE

ADAPTOR PLATE INSTALLATION

th
Century
™
ADDITIONAL HARDWARE
1" x 8-32 ROUNDED
HEAD SCREW (2)
FLAT WASHER
LAG SCREW
/ " #7 X 5" (1)
3
8
JOIST
CEILING FAN
APPROVED
WIRING BOX
CROSSBAR
MOUNTING
BRACKET
FLAT
WASHER
APPROVED
OUTLET BOX
HARDWARE
2 1 " x 8-32 ROUNDED
/
4
HEAD SCREW (2)
FLAT WASHER (2)
LARGE
/ " (1)
3
8
CEILING
WIRING
RIDGE
SIDE
DOWN
GREEN
GROUND
WIRE
5