Casablanca 19th Century Owner's Manual page 13

R
INTELI•TOUCH © INSTALLING THE W-32 WALL CONTROL
The wall control installs in the same manner as an ordinary light switch, using an existing junction box and wiring. This
controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the
following precautions must be observed:
1. Use only the Casablanca W-32 wall control.
2. Do not use any additional control with your Inteli-Touch
fan (for example, dimmer, fan speed control, etc.).
INTELI•TOUCH
CAUTION! Ensure power is turned OFF at the breaker
or fuse panel before starting installation.
W-32 is used to describe either white (-11) or ivory finish.
1. Remove the screws and switch plate from the existing
switch box.
2. Remove the screws holding the switch in the switch box.
3. Pull the existing switch from the switch box to expose the
wire connections.
4. Remove the two wires from the switch.
5. Connect the two wires just removed from the switch to
the W-32 wall control black wire and black/white stripe
wire. Secure these connections with wire nuts.
6. Install the W-32 in the wall box with the two long screws
provided.
7. Install the wall plate with the two color matched screws.
NOTE: If your wall control operation is reversed, i.e., fan
switch controls lights and light switch controls fan, simply
swap the two W-32 black white stripe wires.
/
INTELI•TOUCH
CAUTION! Ensure power is turned OFF at the breaker
or fuse panel before starting installation.
To control the fan and lights from two locations
(a three-way circuit), use 2 W-32 wall controls.
1. Remove the screws and switch plate from the
existing switch box and the screws holding
the switch in the switch box.
2. Pull the existing switch from the switch box
to expose the wire connections.
3. Determine which wire is connected to the com-
mon terminal of the 3-way switch. (The
terminal will be marked on switch).
4. Remove the wire from the common terminal
of the 3-way switch. Connect this wire to the
remaining black white striped wire on the W-
/
32 control. Secure this splice with a wire nut.
5. Remove the two remaining wires from the 3-
way switch. Connect one of these wires to a
black wire on the W-32 control. Secure the
splice with a wire nut. The remaining wire is
to be connected to the other black wire on
the W-32. Secure the splice with a wire nut.
6. Install the W-32 in the wall box with the two
long screws provided.
7. Install the wall plate with the two short color-
matched screws provided.
8. Installation of the second W-32 control is iden-
tical. Repeat steps 1 through 8.
12
3. Do not use more than one fan per wall control.
4. No other light fixtures or electrical appliances may be con-
nected on the circuit controlled by the W-32 wall control
unit.
SINGLE W-32 INSTALLATION
R
DUAL W-32 INSTALLATION
R
NOTE: If your wall control operation is reversed, i.e., fan switch
controls lights and light switch controls fan, simply swap the
two W-32 black white stripe wires.
/
SWAP THESE
TWO WIRES WHEN
NECESSARY
(SEE NOTE BELOW)
SWAP THESE TWO WIRES
WHEN NECESSARY
(SEE NOTE BELOW)
END
R
IN
OF
LINE
LINE