Step 2. Attach the canopy to the crossbar mount-
ing bracket with three of the 8-32 x 2
canopy screws and canopy lock washers.
Tighten the screw firmly by hand only.
Note: On sloped ceilings, align the
canopy opening towards the top or
room peak.
Step 3. To hang the fan body in the
canopy, hold the fan body firmly and in-
sert the ball into the canopy opening.
Check that no wires were pinched. Rotate
the fan body until the slot in the ball fits
into the pin opposite the canopy open-
ing.
NOTE: The fan weight is 30 pounds.
Step 4. Attach the fan wires to the ceil-
ing fixture outlet box wiring by twisting
the bare ends of the wires together and
then securing with a wire nut.
Connect in this order:
• GREEN leads from mounting plate
and fan to GROUND conductor of
power source. Secure with wire nut.
• WHITE wire from fan to white NEU-
TRAL wire in ceiling fixture outlet
box. Secure with wire nut.
• BLACK wire from fan to black (or red)
POWER wire in ceiling fixture outlet
box. Secure with wire nut.
CANOPY INSTALLATION
1
long
/
4
HANGING THE FAN
CANOPY ELECTRICAL CONNECTIONS
BLACK WIRES
(2)
WHITE WIRES
(2)
WIRE NUT
B
ELLA
CROSSBAR MOUNTING
BRACKET INSTALLED
CANOPY
CANOPY LOCK
WASHERS
CANOPY
SCREWS
BALL
SLOT
GREEN WIRES
(3)
™
PIN
5