Ceiling Hardware; Getting Started; Crossbar Mounting Bracket Installation; Canopy Hardware - Casablanca Bella Bellatm Bella Ceiling Fan Owner's Manual

Step E. Install the four 40 watt incandescent light bulbs.
CROSSBAR
MOUNTING
BRACKET
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked ac-
ceptable for ceiling fan support using the mounting
hardware provided with the outlet box.

CROSSBAR MOUNTING BRACKET INSTALLATION

Proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box through
the crossbar mounting bracket center hole. Attach the bracket,
with ground wire and ridges down, to the ceiling fixture out-
let box with the mounting hardware included with the outlet
box.
Tighten the screws firmly by hand only, being careful not to
bend the bracket by over tightening.
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
CANOPY
HATCH
4
INSTALL INCANDESCENT BULBS

CEILING HARDWARE

WIRE NUT (4)

GETTING STARTED

MOUNTING

CANOPY HARDWARE

CANOPY
INCANDESCENT
LIGHT BULBS
(4)
ADDITIONAL HARDWARE
1 x 8-32 ROUND
HEAD SCREWS (2)
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker
or fuse box), lower the old fixture and disconnect the wiring.
Check the ceiling fixture outlet box to be sure that it is
marked 'Approved for ceiling fan mounting' . If it is not, a new
box must be installed.
NOTE: The fan weight is 30 pounds.
CEILING
WIRING
CROSSBAR
BRACKET
FLAT
WASHER
CANOPY LOCK WASHER (4)
1
2 x 8-32 ROUND HEAD
/
4
SCREWS (2)
FLAT WASHER (2)
CEILING FAN
APPROVED
WIRING BOX
RIDGE
SIDE
DOWN
GREEN
GROUND
WIRE
APPROVED
OUTLET BOX
HARDWARE
CANOPY SCREW (4)