Getting Started; Installation On A Ceiling; Mounting Bracket Installation; Canopy Installation - Casablanca Concert Breeze Owner's Manual

GETTING STARTED

This Light Kit can be installed in two different ways. Decide whether to install on the ceiling or to an
compatiable ceiling fan.
To Install on a Ceiling start with Mounting Bracket Installation on Page 6
To Install on an compatiable ceiling fan, start with Installation on a Fan on Page 9
To Install on an Hunter compatiable ceiling fan, start with Installing on a Hunter Ceiling Fan on Page 16.

INSTALLATION ON A CEILING

MOUNTING BRACKET INSTALLATION

CEILING HARDWARE (not to scale)
#8-32 Hex
Nuts
Hanger Bracket
Step 1. If you are replacing an existing light
fixture, disconnect and remove the old fixture and
mounting bracket. Leave the wires coming from the
outlet box exposed.
Step 2. If the ceiling box is recessed use the
longer Canopy Screws.
Step 3. Pre-install the two Canopy Screws, and
the corresponding #8-32 hex nuts on the hanger
bracket, and tighten the hex nuts securely.
Note: The hanger bracket should be positioned so
that the two #8-32 screws are coming down and
the green grounding screw is going up towards the
ceiling.
Step 4. Using the screw holes located on the
electrical box, secure the hanger bracket to the
electrical box by inserting the Ceiling Box screws
through the slotted holes in the hanger bracket and
thread into the ceiling box.
Note: The screws for installing the hanger bracket
to the electrical box should be installed in the
opposite direction as the screws for installing the
ceiling plate cover to the hanger bracket.
6
Ceiling Box
Canopy Screws
Screws
Canopy Screws
Nuts
Step 2
Hanger
Ceiling Box
Bracket
Screws
C
onCert

CANOPY INSTALLATION

Wire Connectors
Canopy
Step 5. Locate the green ground wire from the
canopy and the supply ground wire coming out of
the electrical box. Connect the ground wire from
the canopy and the supply ground wire to the green
ground screw on the hanger bracket. Tighten the
green ground screw.
Step 6. Connect the white wire from the canopy
to the white supply wire coming out of the ceiling.
Connect the black wire from the canopy to the black
supply wire coming out of the ceiling. Secure all wire
connections using approved wire connectors.
NOTE: To connect the wires, hold the bare metal
leads together and place a wire connector over them,
then twist the wire connector clockwise until tight.
Step 7. Spread the electrical splices so that the black
wires are on one side of the outlet box and the white
wires are on the other side.
CAUTION: Be sure no bare metal wires or wire
strands are visible after making the connections.
Step 8. Align the holes in the canopy with the #8-32
canopy screws that were pre-installed on the hanger
bracket. Raise the canopy and insert the screws
through the two holes in the cover plate.
Step 9. Install the spring washers and thumb nuts
on the end of each of the #8-32 canopy screws.
Tighten securely.
B
reeze
Thumb
Spring
Nuts
Washers
Ground
Screw
Canopy
Steps 4
Steps 5-5
Canopy
Spring
Decorative
Washer
Nut
Steps 7-8
7