Crossbar Mounting Bracket Installation; Canopy Hardware; Canopy Installation - Casablanca Metropolitan Owner's Manual

CRoSSBAR moUnTIng BRACKET InSTAllATIon

Proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box
through the crossbar mounting bracket center hole. At-
tach the bracket, with ground wire and ridges down, to
the 'Approved For Ceiling Fan Installation' ceiling fixture
outlet box with the outlet box mounting hardware.
Tighten the screws firmly, being careful not to bend the
bracket by over tightening.
CAuTION: To reduce the risk
of personal injury, use only the
mounting hardware provided
with the approved outlet box to
install the crossbar mounting
bracket.
CAnopy
hATCh
Step 2. Attach the canopy to the crossbar
mounting bracket with three of the 8-32 x 2 ½"
long canopy screws and canopy lock washers.
Hand tighten until snug against the ceiling.
Note: On sloped ceilings, align
the canopy opening towards the
top or room peak.
4
CEIlIng fAn
AppRovED
wIRIng BoX
CRoSSBAR
moUnTIng
BRACKET

CAnopy hARDwARE

CAnopy

CAnopy InSTAllATIon

CRoSSBAR moUnTIng
BRACKET InSTAllED
CEIlIng
wIRIng
flAT
wAShER
AppRovED
oUTlET
BoX
hARDwARE
CAnopy SCREw
CAnopy loCK wAShER
(4)
CAnopy
flAT wAShER
CAnopy
SCREwS
BRACKET
gREEn
wIRE
(4)