Installation - Casablanca Bella Bellatm Bella Ceiling Fan Owner's Manual

W-43
CONTROL
VERSA•TOUCH
CAUTION! DO NOT USE WITH WALL DIMMER.
STANDARD
TOGGLE
SWITCH
SWITCH
COVER
PLATE
Standard Light Switch
Step 1. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step 2. Orient the control holder as shown and line up the
two inner mounting holes with those on the switch.
Step 3. Install and tighten screws by hand only.
VERSA•TOUCH
Wall Installation
Step 1. Locate a
2x4 wall stud in a
convenient loca-
tion.
Step 2. Orient the
control holder as
shown over the
2x4 stud.
Step 3. Use the 1"
wood screws in ei-
ther the inner or
outer mounting
holes. Install and
ANCHOR
tighten screws by
PANHEAD
hand only.
SCREW
Remove Battery Door
Turn control on its front.
Twist a coin to unsnap
the door A. Lift door
away from control B and
remove C.
Changes or modifications not expressly ap-
proved in writing by Casablanca Fan Co. may
void the user's authority to operate this
equipment.
8
VERSA•TOUCH
W-42
W-43
CONTROL
HOLDER
9V BATTERY
CONTROL HOLDER INSTALLATION
INNER
MOUNTING
HOLES
CONTROL
HOLDER
HOLDER INSTALLATION / STORAGE
DRYWALL ANCHOR
VERSA•TOUCH
This device complies with RSS-210 of Industry Canada. Operation is subject to
the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.

INSTALLATION

DRYWALL
ANCHOR
6-32 (2)
ROCKER
TYPE
LIGHT
SWITCH
SWITCH
COVER
PLATE
Rocker Light Switch
Step 1. Break off the two tabs by pushing outward.
Step 2. Remove the two screws holding the switch cover plate.
Do not remove the cover plate.
Step 3. Orient the control holder as shown and line up the two
outer mounting holes with those on the switch.
Step 4. Install and tighten screws by hand only.
Note: The wall anchors and
6-32 x 1" screws may be used in
situations where mounting to a
stud is not possible. Use the inner
mounting holes. After securing the
anchor, discard the anchor's
pointed screws and use the 6-32
decor ovalhead screws supplied.
WOOD
SCREW 1"
DECOR OVALHEAD SCREW
6-32 X 1"
BATTERY INSTALLATION
Install Battery
Press battery into
control aligned as
shown. Observe proper
polarity. Replace the
SNAP PLUG
battery door.
SOCKET
WOOD SCREW
3
SCREW 6-32 X / " 6-32 X 1"
8
1" (2) (2)
REMOVE TABS
Control Storage
Angle control in top first
until the unit can be
gently pushed back and
snapped into place.
Removing Control
Gently Pull the lower edge
of the control out from the
holder.
GUIDE SLOTS
SCREW
(2)
OUTER
MOUNTING
HOLES
TOP
GOES IN
FIRST
8