Installation Instructions; Fan Preparation - Casablanca Bella Bellatm Bella Ceiling Fan Owner's Manual

Bella oman rev-a 05 owners manual

Hide thumbs

Table Of Contents

Table of Contents

Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them

against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.

Setup. Remove the bottom foam from the box

and place the fan rightside up in the foam. This

protects the lamp socket during assembly.

NOTE: If this is the second Versa•Touch fan installed in the same

area, one of the fans MUST have its channel changed. Please refer

to the Versa•Touch section on the bottom of page 9.

ALLEN SET SCREW

⁄

-20 x

(PRE-INSTALLED)

IMPORTANT SAFETY INFORMATION!

BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN, INSTALL THE

THREADED DOWNROD INTO THE MOTOR COUPLING AND LOCK THE ASSEMBLY

Prepare for fan installation as follows:

Step A. Place the downrod through the motor cover as shown.

Route the wires from the fan motor through the Perma • Lock™

downrod and ball assembly.

Tip: The downrod has a tapered thread

that is designed to lock completely when

correctly installed.

Step B. Using the provided allen wrench, loosen the set screw

several turns to allow installation of the downrod. Thread

the downrod into the motor coupling until it stops turning,

this will take at least four and a half full turns.

Step C. Securely tighten the set screw with the provided allen

wrench to ensure safe operation of your fan.

CAUTION: Failure to fully lock in the down-

rod before securely tightening the allen set

screw may cause the fan to separate from

the downrod during normal operation!

Step D. Using the three screws provided, attach the motor

cover to the motor. Tighten firmly by hand only.