Socket 7Qi Quick Start Manual

Use Your Bluetooth Scanner 7Qi
1. Scanning Barcodes
After connecting the scanner to your
device, open an application. Put the cursor
where you want to enter data. Hold the
scanner about 4 inches from the barcode
and press and hold the trigger button.
Keep your hand steady and make sure the
red beam covers the entire width of the
barcode.
By default, the scanner will beep and
vibrate, and the LED will flash green to confirm that data was decoded
and sent to the host device.
2. Simultaneous Scanning and Soft Keyboard Support
The Scanner supports simultaneous use of the barcode scanner and the
Apple iOS on-screen keyboard while entering data into an application.
To open or close the onscreen keyboard, quickly double-press the
power button (like double-clicking a mouse).
After you double-press the power button, the CHS will beep to indicate
that the onscreen keyboard was enabled / disabled.
Watch a video: http://www.youtube.com/watch?v=VhtttoC6ROs
1. Powering ON:
Press and hold down the small
power button until the LED turns
blue and the scanner
beeps twice
2. Powering OFF:
Press and hold down
the small power
button until the
scanner beeps
twice.
page 1 of 6
Choose 2 Rent
Phone 1 (800) 622-6484
Fax 1 (866) 937-8254
info@choose2rent.com
www.choose2rent.com