Lonworks (Fpc-N35): Commissioning Protonode On A Lonworks Network; Commissioning Protonode Fpc-N35 On A Lonworks Network; Instructions To Upload Xif File From Protonode Fpc-N35 Using Fs Gui Web Server; Figure 20: Lonworks Service Pin Location - FieldServer Protocessor ProtoNode FPC-N34 Startup Manual

Triangle Tube's ProtoNode Startup Guide
5

LONWORKS (FPC-N35): COMMISSIONING PROTONODE ON A LONWORKS NETWORK

Commissioning may only be performed by the LonWorks administrator.
5.1

Commissioning ProtoNode FPC-N35 on a LonWorks Network

The User will be prompted by the LonWorks Administrator to hit the Service Pin on the ProtoNode FPC-N35
at the correct step of the Commissioning process which is different for each LonWorks Network
Management Tool.
• If an XIF file is required, see steps in Section 5.1.1 to generate XIF
5.1.1

Instructions to Upload XIF File from ProtoNode FPC-N35 Using FS GUI Web Server

Connect a standard CAT5 Ethernet cable (Straight through or Cross-Over) between the PC and
•
ProtoNode
The Default IP Address of ProtoNode is 192.168.1.24, Subnet Mask is 255.255.255.0. If the PC and
•
ProtoNode are on different IP Networks, assign a static IP Address to the PC on the 192.168.1.xxx
network
• For Windows XP:
Go to
Right-click on Local Area Connection > Properties
Highlight
• For Windows 7:
Go to
>
Right-click on Local Area Connection > Properties
Highlight
ProtoCessor 1991 Tarob Court Milpitas, California 95035 USA Web: www.protocessor.com

Figure 20: LonWorks Service Pin Location

>
>
> >
>
Email: support@protocessor.com
>
>
Page 23 of 40