Table of Contents
Advertisement
Operating instructions and part catalogue, BALE WRAPPING MACHINE, TWISTER
7.2.
Machine levelling
The machine should be levelled before attempting to use. It is necessary for correct operation of
the wrapping machine. To level the machine, it must be set on even base with its draught bar in
the operating position. Support the machine on its foot and disconnect the tractor.
Next set the machine horizontally by adjusting height of the foot as shown in Fig. 12.
Fig. 12 Machine levelling
Next step is to approach the hitch of wrapping machine with the tractor and set it at the position
Fig. 13 Catch setting
best matching the tractor (Fig. 13). To do this
remove the nuts (4) and take out the screws
(2). Loose hitch ear (1) should be set to
match best the tractor. Next, combine it with
the screws and nuts.
There is six heights possible for the hitch ear,
from 460 mm up to 750 mm from the ground
surface.
Advertisement
Table of Contents
