Assembling Machine - UNIA TWISTER Operating Instructions Manual

Operating instructions and part catalogue, BALE WRAPPING MACHINE, TWISTER
6.3.

Assembling machine

The bale wrapping machine, TWISTER, may be delivered disassembled in parts due to the
transportation reasons.
Keep the special caution during the first assembly and connecting of the
machine. Make sure that all safety requirements are met.
The machine assembly should be performed in order with the following steps:

Mount the wheels. Put on the wheels in case the
wrapping machine
dismounted wheels due to the transportation
reasons. Therefor lift and protect the machine, next
put the wheel (1) on the hub (3) and tighten the
nuts (2). The same actions should be performed on
the other side of the machine.

Mount the draught bar. To decrease the
overall dimension of the machine for time of
the transportation, the draught bar (1) will
be folded. To restore its functionality,
connect the cylinder (2) with frame of the
machine, as shown in Fig. 6. Therefor eye
of the cylinder (2) should be set in the
socket sleeve axis fixed with the bolt (4)
protected with a cotter pin (3). From that
moment, the
repositioned with the machines' controller.

Placing additional foil trey. Machine
draught bar is provided with space for the
additional foil tray. The tray (1) should be
fixed at the place shown on Fig. 7 using
the fasteners (2), washers (3) and nuts
(4).
has been delivered
draught bar may
with
2
Fig. 5 Wheel mounting
4
1
Fig. 6 Draught bar mounting
be
1
4
Fig .7 Assembly of the additional foil con-
tainer
1
3
2
3
3
2