Service Settings - UNIA TWISTER Operating Instructions Manual

Operating instructions and part catalogue, BALE WRAPPING MACHINE, TWISTER

8.4.7 SERVICE SETTINGS

That menu allows to do the following:
 Set the bale loading delay time. This refers to the automatic bale loading. The bale presence sensor
S10, must be active during all that time.
 Set delay time from closing (opening) the loader arm to lifting (lowering) the loader.
 Set delay time from end of lifting the bale by loader arm to moving the table to horizontal position.
The time is necessary to steady bale on the table.
 Switch off the check for the bale presence at the older frame of wrapping machine (sensor S10)
 Switch off the foil break control (sensor S15,S16 )
 Set the automatic or manual ejection of the bale from the wrapping machine
 Follow the state of the wrapping machine sensors, S10 – S21
Fig. 34 SERVICE MENU screen view
Page 41