Table of Contents
Advertisement
Operating instructions and part catalogue, BALE WRAPPING MACHINE, TWISTER
8.4.
Machine controller operating
The controller is operated with the voltage of 12 V from the tractor installation. The power cord deliv-
ered with the controller should be connected directly to the rechargeable battery clamps.
The controller will signal emergency sign in case the supply voltage is lower than 10 V or higher than
18 V and will not allow to perform normal operation.
8.4.1. SWITCHING CONTROLLER ON/OFF
Fig. 26 Switching controller on
SETTING DISPLAY CONTRAST
To change the display contrast, press and
hold
button and set the appropriate
contrast with
or
button.
Switched on / off the controller (PILOT)
by pressing the button shown in Fig. 26.
SETTING BUZZER VOLUME
One of the four buzzer volume levels may
be selected. To set the volume press and
hold
button and set expected
volume with
SETTING DISPLAY BRIGHTNESS
Depending on external brightness several
backlight display levels are available for
setting. For this, press and hold
button. After a moment displayed brightness
will start to change automatically. Release
the button when expected backlight ap-
pears,.
Both
BUZZER
VOLUME
DISPLAY BRIGHTNESS are stored after the
power supply is switched off.
or
button.
LEVEL
and
Advertisement
Table of Contents
