Table of Contents
Advertisement
the instrument displays the "Scheduled
Charging" countdown interface.
6. End charging.
•
Method 1: unplug the power plug.
•
Method 2: power off the charging
pile according to its operation
instructions.
7. Double press the remote control key
unlock button
charging connector.
8. Reinsert the charging port protection
cover and close the hatch.
9. Pick up the charging equipment and
store it properly.
REMINDER
•
The charging connector can be
connected before or after setting the
scheduled charging time, but not
after the scheduled time for charging
to start.
•
The scheduled charging function
cannot be used if SOC is below 15%.
DC Charging
Charging in DC mode:
1. Open the charging port hatch and
remove the two protection covers.
2. Insert the charging connector.
146
to unplug the
3. Power on the charging pile.
•
Power on the charging pile according
to its operation instructions.
4. Confirm connection:
•
The charging connector indicator
in the instrument is on.
•
The charging port indicator flashes
green.
5. End charging.
•
Power off the charging pile according
to its operation instructions.
6. Double press the remote control key
unlock button
charging connector.
7. Reinsert the charging port protection
cover and close the hatch.
8. Pick up the charging equipment and
store it properly.
REMINDER
•
The method above is for general
operation and may vary slightly
according to the charging pile used.
Follow the specific charging pile
instructions.
Smart Charging
In order to avoid power loss of the 12V
battery (starter Fe battery), the smart
charging function will activate and the
power from the high-voltage battery is
enabled to charge it when the following
conditions are all met simultaneously:
•
The bonnet is closed.
•
The vehicle is powered off.
•
Battery is allowed to discharge.
•
12V battery SOC is below stipulated
limit.
to unplug the
Advertisement
Table of Contents
