Table of Contents
Advertisement
► Error Code
H2–6744
► Error message
Finisher Failure: #H2-6A63. Check finisher.
► Symptom
Finisher stapler cartridge is not installed into stapler.
► Troubleshooting method
1) Open finisher stapler door to put back cartridge into stapler and then close door. Self-Priming will be executed
automatically if necessary. If stapler warning does not disappear, follow the instructions below :
2) Does finisher stapler input sensor work well?
a) Make sure finisher input sensor cable is connected well to the sensor connector.
b) Make sure finisher input sensor cable is connected well to the main board connector.
c) Replace the finisher stapler cartridge. (JC81-07408A)
d) Replace the finisher stapler. (JC81-07917A)
e) Replace the finisher main board.
3) Check if any debris(staple)existed. Please make sure to remove any debris.
Copyright© 1995-2017 SAMSUNG. All rights reserved.
4. Troubleshooting
4-179
Advertisement
Table of Contents
Troubleshooting
