Advertisement
1-30
1-30
#35 Lowering Speed ADJ.
#35 Lowering Speed ADJ.
This setting is fo
This setting is for adjustment
In case the lowering speed is higher than the specification as mentioned in the service manual, it can be adjusted. When
In case the lowering speed is higher than the specification as mentioned in the service manual, it can be adjusted. When
lowering the setting, the current to the solenoid will be reduced, but this does not mean it affects the lowering speed
lowering the setting, the current to the solenoid will be reduced, but this does not mean it affects the lowering speed
immediately due to tolerance in oil flow and oil characteristics. Further lowering of the setting may be required.
immediately due to tolerance in oil flow and
This setting is applica
This setting is applicable to the FC
#39 Pitching Control
#39 Pitching Control
This enables the
This enables the pitch control that
To use this func
To use this function, an oil pressure
0: disable, 1: enable
0: disable, 1: enable
r adjustment of the maximum
of the maximum lowering spe
oil characteristics. Further lowering of the setting may be required.
ble to the FC models only.
models only.
pitch control that suppresses the r
suppresses the risk of the carrying
tion, an oil pressure sensor is requir
sensor is required.
lowering speed.
ed.
isk of the carrying load to fall dow
load to fall down or unbalanced.
ed.
CHAPTER 1 CONTROLLER
CHAPTER 1 CONTROLLER
n or unbalanced.
Advertisement
