Mitsubishi FB13PNT Quick Start Manual page 175

2-88 2-88
3. 3.39 39 Lo Logi gics cs Fa
Error code: 62 Error code: 62
Situat Sit uation ion Dis Displa
Possible Possible
Faulty EEPROM data, faulty logic unit. Faulty EEPROM data, faulty logic unit.
cause cause
Trigger of Trigger of
ROM/RAM SUM value of logic card is different from check data. EEPROM SUM value of logic card is ROM/RAM SUM value of logic card is
the error the error
from check data. from check data.
code code
Checks Checks
(1) Turn off power, then turn on power in Setup Option Group (1) Turn off power, then turn on power in Setup Option
(2) Set Setup (2) Set Setup O
(3) S (3) Set Setup Option default et Setup Option default
(4) Turn on power in "RUN" mode (4) Turn on power in "RUN" mode
If If fault fault
(5) Disconnect battery plug, then perform inverter (5) Disconnect battery plug, then perform inverter
discharging work discharging work
(7) Replace logic card of logic unit (7) Replace logic card of logic unit
(8) With (8) With service tool, set Setup service tool, set Setup Opt
Set Setup Option default data Set Setup Option default data
Faul ult ( t (62 62) )
play: "6 y: "62". 2". All t All tru ruck o ck oper perati ations ons inh
Option ption Group Group 3 data 3 data
data data
remains remains "62" "62"
Option Group ion Group 3 data 3 data
CHAPTER 2 TROUBLESHOOTING FOR CONTROL CIRCUITS CHAPTER 2 TROUBLESHOOTING FOR CONTROL CIRCUITS
inhibi ibited ted. Li . Line c ne cont ontact actor O or OPEN PEN and
different from check data. EEPROM SUM value of logic card is different
Group3 setting 3 setting
Error code "61" Error code "61"
(6) See troubleshooting for code "61" (6) See troubleshooting for code "61"
MC MC
and pum pump co p conta ntacto ctor OP r OPEN. EN.
502850 502850
different