Advertisement
the clearance between the terminal and stator core.
the clearance between the terminal and
2) 2)
11± 1 N
11± 1 N·m ( 1
·m ( 1.12 ± 0
Replacing Temperature Sensor
Replacing Temperature Sensor
By cutting off the
By cutting off the wire of the current temperature sensor (no
need to remove the sensor), a new temperature sensor can
need to remove the sensor), a new temperature sensor can
be mounted on the opposite side.
be mounted on the opposite side.
Use Araldite (epoxy paste adhesive AV/HV158 or equivalent)
Use Araldite (epoxy paste adhesive AV/HV158 or equivalent)
to secure the temperature sensor.
to secure the temperature sensor.
CHAPTER 3 MOTOR
CHAPTER 3 MOTOR
12.
12. Tight
Tightening
If the high-power cable terminals of the battery-operated
If the high-power cable terminals of the battery-operated
vehicle are not tightened properly, the increased contact
vehicle are not tightened properly, the increased contact
resistance causes excessive heat generation, and could
resistance causes excessive heat generation, and could
cause a fire in the worst case. To prevent accidents and
cause a fire in the worst case. To prevent accidents and
equipment problems, be sure to regularly check the
equipment problems, be sure to regularly check the
tightening torque of the high-power cable terminals. Do not
tightening torque of the high-power cable terminals. Do not
pull the cables to check connections or during adjustment.
pull the cables to check connections or during adjustment.
If the cable terminal sections are moved, re-tighten the
If the cable terminal sections are moved, re-tighten the
connections.
connections.
stator core.
.12 ± 0.1 kg
.1 kgf·m
f·m) [ 8.
) [ 8.11 ± 0.
11 ± 0.74 lb
74 lbf·f f·ft] t]
wire of the current temperature sensor (no
ening of Hi
of High-pow
gh-power Ca
in M8 thread holes.]
in M8 thread holes.]
4) 4)
Secure t
Secu
re the t
paste adhesive AV/HV1580 or equivalent).
paste adhesive AV/HV1580 or equivalent).
1
1
1. 1. New tem
New temperat
perature se
2. 2. Curre
Current tempera
nt temperature senso
er Cable
ble Term
Terminals
inals
CAUTION
CAUTION
1. 1. Left Tr
Left Tractio
action motor (3
terminals)
terminals)
2. 2. Right T
Right Tracti
terminals)
terminals)
1. 1. Pump m
Pump motor (3 te
he tempe
emperatu
rature s
re sensor
ensor using
using Arald
ure sensor
nsor
3. 3. Cu
Cut o
t off ff
ture sensor r
2
2
1
1
n motor (3
raction moto
on motor (3
r (3
1
1
otor (3 termina
rminals) ls)
Araldite
ite (epo
(epoxy xy
3
3
2
2
502713
502713
3-17
3-17
502730
502730
502731
502731
Advertisement
