(Router Ip Address) Setting - Toshiba nv Series Instruction Manual

Figure 3-21
3.3.5 Default gateway IP address (router IP address) setting
When the default gateway (router) is used, set the default gateway IP
address (router IP address).
set.
The following are set to use the default gateway.
• IPF is set to ON with the operation mode switches.
• IP address type is set to [Tool setting].
The default gateway IP address must be set to the identical value of the
network address part (including the subnet part) of the IP address of the
EN811 module to be registered (172.16.64.** in this example).
The following figure shows an example of system configuration and setting.
(172.16.64.100 in this example)(Subnet mask : 255.255.192.0)
An example of multicast routing network setting
Only one default gateway IP address can be
Unified Controller nv series Ethernet (EN811) Module Operation Manual
3.3 Setting with the engineering tool
35