Toshiba nv Series Instruction Manual page 40

Chapter 3 Setting
• When arbitrary setting is used, the EN811 module does not start up until no arbitrary
26
6F8C1358
Class C sets the bits No.6 to OFF, No.7 to OFF, and No.8 to ON of the
operation mode setting switches (MODE) of the EN811 module to
OFF.
IP address : 192.168.0.xx (xx indicates the value of the station
address setting switches)
Subnet mask : 255.255.255.0
Arbitrary setting sets the bits No.6 to ON, No.7 to ON, and No.8 to ON
of the operation mode setting switches (MODE) of the EN811 module
to OFF. In this case, the value set from the tool has precedence over
the value of the station address setting switches.
Note
setting is done from engineering tool.
time, set the operation mode setting switches to the Class B setting and start the
EN811 module. After the startup, change the setting to arbitrary setting, and then
register the IP address.
For registration of multicast, refer to "3.3.2
setting." For the option switches, refer to "3.3.6
Download the registered information to the EN811 module.
To download, display the parameter information, and click [Download
(D)].
Figure 3-9 An example of module parameter registration
When performing arbitrary setting for the first
Multicast address
Option functions."