Functions Of The Parts - Toshiba nv Series Instruction Manual

1.2.2 Functions of the parts

The major functions of the parts are as shown below.
State display LED
Table 1-1 Display on the state display LED and normal display
Name
RUN
(green)
ERR
(red)
HLTH
(green)
L-A
(green)
LNK-A
(green)
ACT-A
(green)
1G-A
(green)
100M-A
(green)
(Note)1.
2.
3.
Station address setting switch (STN-H, STN-L)
Switches to set the station address in hexadecimal. For setting method, refer
to "Chapter 3 Setting."
Operation mode setting switch (MODE)
Switches to set the operation mode. For setting method, refer to "Chapter 3
Setting."
Display
Displays the hardware operation state.
ON: Running
OFF: Down
Displays the hardware operation state.
ON: Down
OFF: Running
Displays the EN module state.
ON: Network parameter is normal
OFF: Network parameter is abnormal
Displays Ethernet A system state.
ON/Blinking: Ethernet transmission is in execution
OFF: Ethernet transmission is under suspension
Displays Ethernet A system link state.
ON: Link has been established normally
OFF: No link has been established
Displays Ethernet A system state.
Blinking: Ethernet transmission is in execution
OFF: Ethernet transmission is under suspension
Link has been established at 1Gbps
Link has been established at 100Mbps
If 1G-A and 100M-A are OFF, a link has been established at 10Mbps.
Check the LED states from the front.
Refer to "Table 5-1 Diagnosis using the LEDs."
Unified Controller nv series Ethernet (EN811) Module Operation Manual
1.2 Names and functions of the parts
Normal
display
ON
OFF
ON
ON／Blinking
ON
Blinking
－
－
5