Station Address Setting Switch; Stn-Hstn-L - Toshiba Vm Series Instruction Manual

Chapter 3 Setting
3.1 Switch Setting
3.1.1 Station address setting switch (STN-H, STN-L)
The station address setting switches are hexadecimal rotary switches that
determines the station address on the TC-net 100 network.
For setting of the IP address, refer to "3.2 Network parameter setting." Set the
station address (1 to 254) that has been assigned upon system configuration in
a HEX code. Assign an address with a different value to each of the nodes in
the system.
Table 3-1 shows the setting of a station address.
Set the station address in hexadecimal.
For example, if the address value is 28, it is '1C' (h) when converted to
hexadecimal. Therefore, set as follows:
STN-H side: '1'
STN-L side: 'C'
For decimal-hexadecimal conversion, refer to "Appendix D
hexadecimal conversion table."
16
6F8C1637
Table 3-1 Station address setting
Name
STN-H
STN-L
(Note) (h) indicates hexadecimal.
Remark
 For setting, use a small slotted screwdriver.
Note
 Be careful so that the address does not overlap with other nodes.
Description
Setting range : 01 to FE(h)
STN-H(upper digit address): 0 to F(h)
STN-L(lower digit address): 0 to F(h)
Decimal-