ITech IT8511A Manual page 65

th
26 byte
NOTE
Represent calibration protection state by one byte. Each byte is defined as:
From high to low
7 6 5 4 3 2 1 0
0 byte： protection state， 0 represent not in the protection state ， 1 represent
in protection state.
38. Calibrate voltage value（62H）
st
1 byte
nd
2 byte
rd
3 byte
th
4 byte
th th
From 5 to 25 byte
th
26 byte
NOTE
Current calibration standard points have four: 1, 2, 3,4.
39. Sending the actual input voltage to
calibration program（63H）
st
1 byte
nd
2 byte
rd
3 byte
th
4 byte
th
5 byte
th
6 byte
th
7 byte
th th
From 8 to 25 byte
Sum code
Start bit ( AAH )
Address (0—0XFE)
Command（62H）
Voltage calibration point（1~4）
System reserve
Sum code
Start bit ( AAH )
Address (0—0XFE)
Command（63H）
The lowest byte of actual voltage
The lower byte of actual voltage
The higher byte of actual voltage.
The highest byte of actual voltage.
System reserve
65