Toggled Transient Operation - ITech IT8511A Manual

Shift
and
2. Press
Transition mode is PULSE .
Shift
and
3. Press
Shift
and
4. Press
more pulse.
Shift
and
5. Press

Toggled Transient Operation

In this mode, after transition operation start, Load could change the input
between the main level and the transient level when toggled transient
operation is in effect.
For example:
When Load receives one trigger signal, Load current will switch between 5A and
10A.
10A
5A
TRG
Toggled Transient Operation
Action
Shift
1. Press and
mode is PULSE .
Shift
2. Press and
Shift
3. Press and
Shift
4. Press and
Shift
and
5. Press
S-Tran
,
set LEVER A=5A, LEVER B=10A, WIDTH B=10mS,
Tran
to activate the transient mode.
Trigger
to start another pulse. Press
Tran
again to stop the transient operation.
TRG
S-Tran
, Setting LEVER A=5A, LEVER B=10A, Transition
Tran
to activate the transient mode.
Trigger
switch to the current value of 10A.
Trigger
, switch between 5A
Tran
again to stop the transient operation.
Shift
Trigger
and
and 10A.
, get
42