ITech IT8511A Manual page 47

2． Address range from 0 to FE, occupies one byte.
3． Each command occupies one byte. Following is the command details.
20H Selecting the Remote control mode
21H Selecting the input on/off state
22H Setting the max input voltage
23H Reading the max setup input voltage.
24H Setting max input current
25H Reading the max setup input current.
26H Setting max input power.
27H Reading the max setup input power.
28H Selecting CC/CV/CW/CR operation mode of Electronic load.
29H Reading the operation mode.
2AH Setting CC mode current value
2BH Reading CC mode current value
2CH Setting CV mode voltage value
2DH Reading CV mode voltage value
2EH Setting CW mode watt value
2FH Reading CW mode watt value
30H Setting CR mode resistance value
31H Reading CR mode resistance value
32H Setting CC mode transient current and timer parameter.
33H Reading CC mode transient parameter
34H Setting CV mode transient voltage and timer parameter.
35H Reading CV mode transient parameter
36H Setting CW mode transient watt and timer parameter
37H Reading CW mode transient parameter
38H Setting CR mode transient resistance and timer parameter
39H Reading CR mode transient parameter
3AH Selecting the list operation mode (CC/CV/CW/CR)
3BH Reading the list operation mode.
3CH Setting the list repeat mode (ONCE / REPEAT)
3DH Reading the list repeat mode.
3EH Setting the number of list steps.
3FH Reading the number of list steps
40H Setting one of the step's current and time values.
41H Reading one of the step's current and time values.
42H Setting one of the step's voltage and time values.
43H Reading one of the step's voltage and time values
44H Setting one of the step's power and time values
45H Setting one of the step's power and time values.
46H Setting one of the step's resistance and time values
47H Reading one of the step's resistance and time values
47