A Cfast Card Cannot Be Accessed; Device Data Cannot Be Displayed In Got; Communication Cannot Be Performed; Installation Of A Melsoft Product Fails - Mitsubishi Electric MELSEC iQ-R Series User Manual

34.20

A CFast Card cannot be Accessed

Check item
Is a CFast card inserted into the CFast card slot?
Has the CFast card been removed from the CFast card slot while the power of
this product is ON?
Has the CFast card been inserted into the CFast card slot while the power of
this product is ON?
Has the CFast card been formatted?
Is the CFast card broken?
34.21

Device Data cannot be Displayed in GOT

Check item
Is 'SLMP' selected for the communication method?
34.22
RS-232 Communication cannot be Performed
Check item
Is the RS-232 cable wired incorrectly?
Is the RS-232 cable disconnected?
Are the communication settings between this product and connected devices
the same?
34.23

Installation of a MELSOFT Product Fails

Check item
Is an installer other than the English version used?
34 TROUBLESHOOTING BY SYMPTOM
262
34.20 A CFast Card cannot be Accessed
Corrective action
Turn the power of this product OFF, and insert or reinsert a CFast card into the
CFast card slot.
Turn the power of this product OFF, then turn ON the power again.
Format the CFast card.
Replace the CFast card.
Corrective action
To connect to a GOT, set the communication method to "MELSOFT
Connection" in the external device configuration.
Corrective action
Wire the RS-232 cable correctly.
Replace the RS-232 cable.
Set the same communication settings.
Corrective action
Install the product with the English version installer.
To install products in a language other than English, uninstall all the pre-
installed applications shown below:
• CW Configurator
• Motion Control Setting
• MR Configurator2
• Simple Motion Module Setting
After uninstalling the applications, install them in a language to be used.