Mitsubishi Electric MELSEC iQ-R Series User Manual page 96

■Graphics Configuration
Settings for graphics are displayed.
Item
GTT Size
Aperture Size
DVMT Pre-Allocated
DVMT Total Gfx Mem
■PCI Configuration
Settings for PCI are displayed.
Item
PCI SERR# Detection
Fatal Error
Non Fatal Error
Correctable Error
■ATA Configuration
Settings for Serial ATA are displayed.
Item
SATA1 (CFast1)
SATA2 (CFast2)
SATA Transfer Rate
SATA1 (CFast1)
SATA2 (CFast2)
9 MAINTENANCE AND INSPECTION
94
9.3 BIOS Setup
Description
Set the size of graphics memory used before the OS boot.
• 2MB: The size is set to 2 MB.
• 4MB: The size is set to 4 MB.
• 8MB: The size is set to 8 MB. (Default)
Set the aperture size (memory space).
• 128MB: The size is set to 128 MB.
• 256MB: The size is set to 256 MB. (Default)
• 512MB: The size is set to 512 MB.
Set the minimum value for a memory used by a graphics driver.
• 64MB: The minimum value is set to 64 MB. (Default)
• 128MB: The minimum value is set to 128 MB.
• 256MB: The minimum value is set to 256 MB.
• 512MB: The minimum value is set to 512 MB.
Set the maximum value for a memory used by a graphics driver.
• 128MB: The maximum value is set to 128 MB.
• 256MB: The maximum value is set to 256 MB. (Default)
• MAX: The maximum value is set to 1 GB.
Description
Set whether to detect PCI SERR# in a device connected to PCI Express.
• Disabled: The PCI SERR# detection is disabled.
• Enabled: The PCI SERR# detection is enabled. (Default)
Set whether to detect a fatal error in a device connected to PCI Express.
• Disabled: The fatal error detection is disabled.
• Enabled: The fatal error detection is enabled. (Default)
Set whether to detect a non-fatal error in a device connected to PCI Express.
• Disabled: The non-fatal error detection is disabled. (Default)
• Enabled: The non-fatal error detection is enabled.
Set whether to detect a correctable error in a device connected to PCI Express.
• Disabled: The correctable error detection is disabled. (Default)
• Enabled: The correctable error detection is enabled.
Description
The name of CFast1 is displayed.
The name of CFast2 is displayed.
Set the transfer rate of CFast.
• 1.5Gbps: The transfer rate is limited to up to 1.5 Gbps.
• 3.0Gbps: The transfer rate is limited to up to 3.0 Gbps.
• 6.0Gbps: The transfer rate is limited to up to 6.0 Gbps. (Default)
Set whether to enable CFast1.
• Disabled: CFast1 is disabled.
• Enabled: CFast1 is enabled. (Default)
Set whether to enable CFast2.
• Disabled: CFast2 is disabled.
• Enabled: CFast2 is enabled. (Default)