Mitsubishi Electric MELSEC iQ-R Series User Manual page 55

■When CW Configurator is not connected to the actual system configuration
Create the module configuration manually to set parameters.
Operating procedure
1.
Select a base unit to be used from the element selection window, and drag and drop it onto the module configuration
diagram.
2.
Drag each module to be used and drop it onto the base unit placed in the diagram.
3.
Select [Edit]  [Parameter]  [Fix].
4.
Double-click a module to display the parameter editor for the module.
Set parameters.
5.
Click the [Apply] button.
■Parameter settings from the navigation window
Set the following parameters from the navigation window.
Parameter
System parameter
Module parameter of a CPU module
Multiple module parameters and
module extended parameter
Settings with the module configuration diagram and settings by system parameter are used properly as
follows depending on their usage.
• Module configuration diagram: Module-specific information such as the number of occupied points is used
without changing.
• System parameter: The number of slots of a base unit or the number of occupied points for a module is
changed.
Description
To change the number of slots of a base unit or the number of occupied points for a module as well as to configure the
multiple CPU setting or synchronization setting, the system parameter is set from the navigation window.
• [Navigation window]  [Parameter]  [System Parameter]
To use a built-in Ethernet function for a CPU module, setting the module parameter for the CPU module is required.
• [Navigation window]  [Parameter]  [(CPU module)]  [Module Parameter]
Some intelligent function modules may require parameter settings for multiple modules or module extended parameter
setting.
• [Navigation window]  [Parameter]  [Module Information]  [(each intelligent function module)]  [Module
Extended Parameter] or [Module Parameter]
4 PROCEDURES BEFORE OPERATION
4.4 Setting Parameters
4
53