Table of Contents
Advertisement
Frequency Lock / Dedicated EARFCN – You can specify up to 9 frequencies or E-UTRA Absolute
•
Radio Frequency Channel Numbers (EARFCNs) the CPE will scan during its routine signal scan. The
frequency/EARFCN information will come from the service provider.
•
Cell Lock / PCI Lock - A combination of Physical Cell Identifier (PCI) + EARFCN or frequency. The
CPE will scan only the list of eNBs with the PCI and EARFCN combination, which accelerates
network access time.
•
PCI-only Lock – You can lock the CPE to a designated PCI or PCI range.
If you wish to leave the scan mode as Full Band, you do not need to make any configuration changes for
the mode The procedures for configuring the other three modes are described for CAT4 and for CAT6/7/15
in the sections that follow.
7.5.2 CAT4
Following are the procedures for configuring Frequency Lock, Cell Lock, and PCI Lock on a CAT4 CPE.
Frequency Lock (Figure 35)
•
1. For Scan Mode, select Frequency Lock from the pull-down menu.
2. Click on ADD LIST to open the Frequency Lock Setting pane.
3. Select the Band number, and enter the Earfcn.
4. Click on ADD. Then click SAVE & APPLY.
Figure 35: Frequency Lock (CAT4)
32
Advertisement
Table of Contents
