The initial value by a reset action
A clock setup is initialized to the following states by a reset action.
External high speed oscillator
Internal high speed oscillator 1
Internal high speed oscillator 2
External low speed oscillator
PLL (multiplying circuit)
Gear clock
Note: The state after the initialization done by the reset from the pin depends on [RLMLOSCCR]<POSCEN>
setting.
: Stop
: Oscillation
: Stop (Note)
: Stop
: Stop
: fc (no frequency dividing)
12 / 88
TMPM4G Group(1)
Clock Control and Operation Mode
TXZ+ Family
2021-06-30
Rev. 1.1