Table of Contents
Advertisement
P/N 0467434_P
REPLACING HAND RAIL
Beginning at one end, remove the hand rail
by pressing down, 1, and back, 2, to release
the back corner from its retainer (refer to the
following illustration). Work along the back
(inside) until the full length is free. Rotate the
hand rail out to release the front edge.
To reinstall, catch the front edge of the hand
rail retainer with the inside front of the hand
rail as shown in the following illustration, 1.
Rotate the hand rail in toward the case and
press down, 2, until back of hand rail snaps
over back of retainer.
Hand Rail Snapped onto Retainer
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
REPLACING PANEL EDGE GUARD
Beginning at one end of the edge guard, insert
a thin wide plastic tool (such as a putty knife)
to separate the guard from the panel until a
finger can be inserted to rotate the guard off
the panel. Work the length of the panel.
To reinstall, hook the curved leg of the edge
guard behind the flange on the lower front
panel. Rotate the edge guard forward to
snap onto the lower front panel. Refer to the
following illustrations.
Edge Guard Snapped onto Lower Front Panel
Low Temperature
6-15
Excel
Advertisement
Table of Contents
