Table of Contents
Advertisement
P/N 0420057_B
REPLACING GLASS HAND GRIP
The hand grip is fastened to the curved glass as
shown below. A 2 inch (51 mm) bead of silicone
needs to be placed 3 inches (76 mm) from each
end and in the center of the hand grip. The duct
tape is placed on the glass to provide a tight fit.
Duct Tape
Glass
3
/
in. (10 mm)
8
3 in.
(76 mm)
HINGE HARDWARE
Type: Two cylinders and one fastening point.
P/N 0401884
Used on: 8 ft and 12 ft (2438 mm and 3658 mm)
parent cases and as a joining bracket.
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.
3
/
in. (10 mm) of
8
Duct Tape on Each
Side of Bottom
Edge of Glass
Start 2 in. (51 mm)
Silicone Bead
3 in. (76 mm)
From Each End
Glass Grip
Type: Two cylinders and three fastening points.
P/N 0407352
Used on: 30° outside wedge.
Type: Three cylinders and four fastening points.
P/N 0412538
Used on 90° inside wedge, 45° outside and inside
wedge, 30° inside wedge.
Note: This hinge assembly, when used on the 90°
and 45° inside wedge, uses only two cylinders.
Type: Four cylinders and five fastening points.
P/N 0413170
Used On: 90° outside wedge.
Service Merchandisers
6-7
Advertisement
Table of Contents
