Table of Contents
Advertisement
s
6-8
eRVIce
REPLACING PRODUCT SIDE HEATER
(FWGH & FWEGH ONLY)
To replace the heater:
1. Turn OFF the power to the merchandiser.
2. Remove return grilles, package guard and
interior panel from the compartment being
serviced.
3. Remove the pop rivets. Rivets will be
drilled out. Unplug existing product side
heater. Heater is routed on RH side from
front of merchandiser (end opposite the
main serial plate).
4. Clean thoroughly. Remove all adhesive
and residue. Wipe surface with alcohol
to ensure new heater tape will adhere
properly.
Place Heater Wires as close to
this bend as possible. Heater
wires to exit on same side as
outside return air heater
Heater Wire 120V 96W
(Qty 1)
0544703
P/N 0467434_P
Return Heater Retainer
(Qty 1)
Pop Rivet
(Location)
Stiffener Panel (4ft)
(Qty 3)
Interior Glass Panel
(Qty 1)
A
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
5. Install new heater and tape in retainer as
shown.
6. Reinstall retainer, routing plug to jumper
harness; plug in.
7. Reinstall wireway cover, interior panel,
package guard, return air grilles, display
pans and wire racks.
8. Turn on power to merchandiser and check
for proper operation.
Pop Rivet .125 diameter
Pop Rivet through all 3 parts - 6 places
Pop Rivet through panel and stiffener - 3 places
Heater not shown in this view
Advertisement
Table of Contents
