Table of Contents
Advertisement
P/N 0467434_P
3-5
To install the cove trim to the splashguard:
1. Remove all dirt, wax and grease from the
area of the splashguard where adhesion will be
necessary to ensure a secure installation.
2. Apply a good contact cement to the cove
trim and allow proper drying time according
to the directions supplied with the cement.
3. Install the trim to the splashguard so that it
is lying flush with the floor. d
o not seal the
.
trim to the floor
4. If required by local health codes the Cove
Trim may be sealed to the floor, using a
silicone type sealer. Sealant must be removed
and replaced when servicing.
Excel
Low Temperature
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Advertisement
Table of Contents
