Table of Contents
Advertisement
I
1-18
nstallatIon
Offsetting Bumper (for End Merchandisers)
1. Locate starter bumper shipped with the
left-end kit.
2. Remove factory installed bumper by
pulling bumper away from bumper retainer.
Be careful not to lose the internal joint trim on
the bumper.
3. Starting at the left end of the lineup, install
the bumper starter section first. To install:
a. Position internal joint trims so that the
first is flush to the left-end panel and the
second is centered between the starter bumper
and the full-length bumper as shown.
b. Install full-length bumpers and internal
trims offset across joints. Make sure that
no gaps exist between sections. Continue
installing the bumpers the length of the lineup.
P/N 0467434_P
Starter
Bumper
Internal Joint Trims
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
4. Once all except the last section of
bumper have been installed, refrigerate the
merchandiser lineup for at least six (6) hours.
The last section of bumper should be kept inside
a cooler or refrigerated merchandiser during this
time. This will allow the bumper to contract.
5. Go to the right end of the lineup and tap
the bumper to close any gaps.
6. Measure and cut last
section of bumper. Use a miter
box and fine-tooth saw to cut
last bumper to length. Install
the last section.
7. Remove protective film
from bumper once installation
is complete.
Merchandiser
Joint
Full Length
Bumper
Bumper
Miter Box
Advertisement
Table of Contents
