Replacing Glass Hand Grip; Hinge Hardware - Hussmann IMPACT ED1 Installation And Operation Manual

P/N 406928

REPLACING GLASS HAND GRIP

The hand grip is fastened to the curved glass as
shown below. A 2 inch (51 mm) bead of silicone
needs to be placed 3 inches (76 mm) from each
end and in the center of the hand grip. The duct
tape is placed on the glass to provide a tight fit.
Duct Tape
Glass
3
/ in. (10 mm)
8
3 in.
(76 mm)

HINGE HARDWARE

Type: Two cylinders and one fastening point.
P/N 0401884
Used on: 8 ft and 12 ft (2438 mm and 3658 mm)
parent cases and as a joining bracket.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 (Printed in U.S.A.)
3
/ in. (10 mm) of
8
Duct Tape on Each
Side of Bottom
Edge of Glass
Start 2 in. (51 mm)
Silicone Bead
3 in. (76 mm)
From Each End
Glass Grip
Type: Two cylinders and three fastening points.
P/N 0407352
Used on: 30° outside wedge.
Type: Three cylinders and four fastening points.
P/N 0412538
Used on 90° inside wedge, 45° outside and inside
wedge, 30° inside wedge.
Note: This hinge assembly, when used on the 90°
and 45° inside wedge, uses only two cylinders.
Type: Four cylinders and five fastening points.
P/N 0413170
Used On: 90° outside wedge.
E E u u r r o o D D e e l l i i M M e e r r c c h h a a n n d d i i s s e e r r s s
6-7