Table of Contents
Advertisement
s
6-12
eRVIce
REPLACING DISCHARGE
THERMOPANE GLASS ASSEMBLY
(FNG and FIG)
Requires TWO (2) people.
Always use gloves when handling glass.
1. Turn off power to merchandiser.
2. Remove louvers, package guards, discharge
rear deflector module and hand rail. (Hand
rail removal is shown on Page 6-9.)
3. Disconnect glass pane heater lead wires
from the wiring junctions.
4. With one person standing at each end of
glass, lift the thermopane glass assembly
straight up to remove it from its retainer
channel and the end posts.
5. To install glass, have one person hold each
end of the thermopane glass assembly and
care fully lower it into the retainer channel
and end posts.
NOTE: It may be necessary to use a wide, thin
tool (such as a putty knife) to keep trim from
obstructing glass positioning.
6. Reconnect glass pane heater lead wires.
7. Reinstall hand rail, discharge rear
deflector, package guards and louvers.
8. Turn on power. Verify that heater is
working properly.
P/N 0467434_P
To avoid serious injury or death from electrical
shock, always disconnect the electrical power
at the main disconnect when servicing or
replacing any electrical component. This
includes, but is not limited to, such items as
doors, lights, fans, heaters, and thermostats.
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
— LOCK OUT / TAG OUT —
Advertisement
Table of Contents
