Table of Contents
Advertisement
I
1-10
nstallatIon
5. Align end case with wide island frame.
Fastener size and location are detailed in pages
1-12 and 1-13. Loosely assemble bolt, washers,
lockwasher and nuts as shown here.
N
ote that aligNmeNt order is differeNt from
!
tighteNiNg order
Do not attempt to draw merchandisers together
using nut and bolt.
NOTE: H-Shaped Joining Clip is not used when
joining end merchandisers with stainless steel
rails.
Bumper retainers allow for slight lateral
movement for both solid and glass front
merchandisers.
6. Join bumper retainers.
Joining brackets are installed in factory. Be
sure to loosen joining bracket screws before
tightening and joining the bumper brackets.
Tighten the screws of joining brackets after
tightening the other screws according to
Sequence 6A and 6B for FW cases on Page
1-13, and Sequence 8 and 9 for FI cases as
shown on Page 1-13.
P/N 0467434_P
NOTE: Joining hardware is shown enlarged for clarity.
Screw-Cap
5
/
Screw SM #10-12 x
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
Bumper Retainer
-18 x 1
3
/
16
4
/
1
2
Flat Washer
/
5
16
Lock Washer
/
5
16
Hex Nut
5
/
- 18
16
Joining Brackets
Bumper Retainer
Advertisement
Table of Contents
