Yamaha VK10L Manual page 54

È
LT
2
1
É
2 1
LT
STEERING SYSTEM
Toe-out adjustment
1. Place the machine on a level surface.
2. Measure:
3. Adjust:
Adjustment steps:
• Loosen the locknuts (tie-rods) 1.
LT
LT
• Turn the tie rods 2 in or out until the specified
1
• Tighten the locknuts (tie-rods) 1.
2
After tightening the inside and outside ball joint
locknuts 1, make sure the tie rods 2 can be
LT
1
rotated freely through the ball joint travel. If not,
loosen the locknuts 1 and reposition the ball
joint so that the tie rods 2 can be rotated freely.
Tighten the locknuts to specification.
È Outside
É Inside
18
• Ski toe-out (a – c)
• Ski stance b
Point the skis forward.
Out of specification → Adjust.
Ski toe-out:
0 ~ 15 mm (0 ~ 0.59 in)
Ski stance (center to center):
1,020 mm (40.2 in)
• Ski toe-out
toe-out is obtained.
Tie-rod end locknut:
25 Nm (2.5 m · kg, 18 ft · lb)
®
LOCTITE
CAUTION:
INSP
ADJ