Removal; Inspection - Yamaha VK10L Manual

DRIVE CHAIN HOUSING
1
2
68

REMOVAL

1. Remove:
• Reverse driven gear 1
NOTE:
While holding the front axle assembly with spanner
wrench 2, loosen the reverse driven gear bolt.

INSPECTION

1. Inspect:
• Drive chain housing 1
• Drive chain housing cover 2
Cracks/damage → Replace.
• Shift fork 3
Pitting/wear/damage → Replace.
• Oil seals (drive chain housing and cover)
Wear/damage → Replace.
• Bearings (drive chain housing and cover) 4
Pitting/damage → Replace.
Replacement steps:
• Remove the circlip (drive chain housing and
cover).
• Remove the bearing(s) using a general bearing
puller.
• Install the new bearing(s).
NOTE:
Use a socket 5 that is the same size as the outside
diameter of the bearing race.
CAUTION:
Do not strike the inner race 6 or ball bearings
7.
Contact only the outer race 8.
• Install a new circlip (drive chain housing and
cover).
CAUTION:
Always use new circlips.
POWR
TR