Notification & System Messages - Vidicode V-Tap ISDN PRI Manual

6 Notification & System Messages
The following audio files are used by the system:
NOTIFY.WAV
NOUTG.WAV
NBEEP.WAV
BEEPS.WAV
ALERT.WAV
Format of the messages:
G.711 A-Law, 8000 Hz (64 Kbps), Mono.
Putting the messages onto the system:
1. With an SD card:
Put your .WAV file(s) in the root of an SD card.
Insert the SD card into the V-Tap. The system will automatically copy
the file(s) to its internal memory and delete the file(s) from the card.
Then the system reboots and the new messages are used.
2. With FTP:
Connect to the V-Tap with FTP and upload your .WAV file(s).
V-Tap ISDN PRI Manual EN v1.3 Okt 2018
: The Notification message. This file is played by the
system when the notification is enabled and a
recording starts. The message usually says something
like: "Welcome.... this call will be recorded...".
Also, each time DTMF ** starts a recording, this
message is heard.
: Notification message for outgoing calls. This is used
when notification is enabled and when this file exists.
Default, this file does not exist on the system.
: Notification beep. Used when
the App Special Flags. A short beep is heard by both
parties during the whole conversation.
: System beeps. This file is played by the system and
heard by both parties of the call when a recording is
stopped with DTMF ** or when a recording starts and
NOTIFY.WAV does not exist.
: Alerting (ringing) tone. This message is heard by the
caller, after the system played the notification and
transferred the call to the PBX, before the local phone
is picked up. Only used in pre-notification mode.
is entered in
.IB<sec>
" "
© 2018 Vidicode 38