Software Installation; Call Recorder Apresa - Vidicode V-Tap ISDN PRI Manual

2.2

Software installation

External software is needed to extract the recorded calls from the
Tunnel data that is produced by the V-Tap ISDN. Also, when the calls are
first stored on an SD card, external software is needed to interpret this
data from the card, especially when the data is encrypted.
The Tunnel data stream, coming from the V-Tap, can be send to the Call
Recorder Apresa or the Call Recorder VoIP software.
NOTE:
The V-Tap needs at least one Apresa or PC upload-channel license key
before the Apresa or CR-VoIP software can record your calls.
2.2.1
The Call Recorder Apresa is recorder software running on the Linux
operating system. The Apresa can receive Tunnel data from the V-Tap,
convert this data into audio files and store these into its own database.
The Apresa can receive multiple data streams from many V-Tap units
simultaneously. In that case the recordings of different locations are
centrally stored in one database.
To setup the Apresa to act as a Tunnel server for a V-Tap, go to
System settings, Network tab and enable "V-Tap" as is shown below:
NOTE1: Apresa's IP address is the "Tunnel Server Address" in the V-Tap.
NOTE2: Be sure the Encryption password is the same as in the V-Tap unit.
V-Tap ISDN PRI Manual EN v1.3 Okt 2018

Call Recorder Apresa

© 2018 Vidicode 8