Advertisement
Available languages
Available languages
1. Open dispenser cover.
2. Push in the slide until the dispensing opening is
exposed. (See Figure 3)
Figure 3
Slide
3. Select appropriate dispensing opening on insert
and rotate into position until it locks into place.
Release the slide so it fully opens. (See Figure 4)
Figure 4
Insert
#4
#2
ITEM #
S-7724
S-15752
S-7725
S-11827
S-12851
NOTE: Dispenser comes with turn knob installed,
not keyed lock. If keyed lock is desired, see
instructions below.
KEYED DOOR OPERATION
1. Open dispenser to reveal latch mechanism on side
of cover. Release latch button by removing pin in
latch button stem. Pull latch button out and save for
future use. (See Figure 7)
2. Insert key and turn.
PAGE 2 OF 6
LOADING INSTRUCTIONS
Dispensing Opening
#3
#1
BRAND
SETTING
Uline
#3
Uline
#3
Scott
#1
Scott
#1
Kleenex
#3
KEY INSTRUCTIONS
4. Start roll from center by pulling out approximately
6" of leading edge.
5. Load roll by feeding leading edge downward into
opening. Make sure that roll is seated completely in
recess of dispenser. (See Figure 5)
Figure 5
6. Close the cover firmly while making sure the towel
doesn't get caught inside.
NOTE: If cover is not locking, twist key
counterclockwise to close latch mechanism.
7. Begin dispensing. Tear off the first few crumpled
sheets. (See Figure 6)
Figure 6
NOTE: To clean, use a soft wipe with mild soap
and water.
Figure 7
1-800-295-5510
uline.com
Dispensing Opening
Recess
Latch Button
Pin
0721 IH-1132
Advertisement
