Caliper Disassembly - Yamaha DT200L 1984-1988 Service Manual

CHAS (^
'Q
FRONT BRAKE
2. Replace the pads as a set if either is found
to be worn to the wear limit.
* 0. 8 mm (0. 031 in)
4. Install:
• Pad springs (New)
• Pads (New)
c^>C
NOTE:
Be sure to position the pad so that its round side
is backward C2).
5. Apply:
• Lithium base grease
Apply a light coating of grease to the re-
taining bolt.
6. Set the caliper body at the original position.
7. Install:
• Retaining bolt
18Nm(1.8m-kg, 13ft-lb)
Caliper Disassembly
1. Remove:
• Retaining bolt
• Pads
• Pad springs
Refer to "Caliper Pad Replacement"
section.
6-14