Yamaha DT200L 1984-1988 Service Manual page 35

INSP
FRONT FORK OIL CHANGE ADJ
6. Place the open container under each drain
hole.
7. Remove:
• Drain bolt ®
Drain the fork oil.
WARNING:
Do not let oil contact the disc brake com-
ponenets. If any oil should contact the brake
components, it must be removed before the
motorcycle is operated. Oil will cause
diminished braking capacity and will
damage the rubber components of the brake
assembly.
8. Inspect:
• Cap bolt 0-ring
• Drain bolt gasket
Damage — Replace.
9. Install:
• Drain bolt
10. Fill:
• Fork oil
*\1 0 Fork Oil Capacity (Each Fork):
366 cm3 (12. 9 Imp oz, 12. 4 US oz)
Recommended Oil:
SAE 10W30 Type SE Motor Oil
After filling, pump the forks slowly up and down
to distribute the oil.
11. Install:
• Components in above list (Step "5")
WARNING:
Always use a new stopper ring (spring wire
circlip).
2-20